Hello Philip,
power LED is on, the next LED is off, the next two LEDs are either blinking or on. It is NOT this way here. Regardless of whether USB stick is in or not LEDs 3 and 4 are dark. Is there a place I can download correct image for USB key from?
-- With Best Regards, Marat Khalili On 27/01/16 14:01, Philip Homburg wrote:
On 2016/01/27 11:10 , Marat Khalili wrote:
Every time after the boot sequence ends first light glows steadily and adjacent one blinks slowly, like it is supposed to be according to https://atlas.ripe.net/about/faq/#what-do-the-lights-on-the-side-of-the-prob... . Looks like the interface just isn't up in the device OS. Is there anything else I can check? Should I request another probe? (it took more than month to receive first one by post) Hi,
After a few minutes, probes as shipped reach the situation where the power LED is on, the next LED is off, the next two LEDs are either blinking or on. The WPS LED seems to have mind of its own, and should ignored.
If that is not the case then it is either a power issue or somebody played with the USB stick.
To detect network activity when there might be an issue with the USB stick, remove the USB stick and power on the probe. The probe should reach a situation where the power LED is on and the next LED is blinking.
In that state the probe will try to a get an address using DHCP, will do IPv6, an on the probe page, new entries in the 'SOS History' history section should show up. This should be enough for basic network connectivity tests.
Philip