On 2016/01/27 11:10 , Marat Khalili wrote:
Every time after the boot sequence ends first light glows steadily and
adjacent one blinks slowly, like it is supposed to be according to
https://atlas.ripe.net/about/faq/#what-do-the-lights-on-the-side-of-the-probe-mean
. Looks like the interface just isn't up in the device OS. Is there
anything else I can check? Should I request another probe? (it took more
than month to receive first one by post)
Hi,
After a few minutes, probes as shipped reach the situation where the
power LED is on, the next LED is off, the next two LEDs are either
blinking or on. The WPS LED seems to have mind of its own, and should
ignored.
If that is not the case then it is either a power issue or somebody
played with the USB stick.
To detect network activity when there might be an issue with the USB
stick, remove the USB stick and power on the probe. The probe should
reach a situation where the power LED is on and the next LED is blinking.
In that state the probe will try to a get an address using DHCP, will do
IPv6, an on the probe page, new entries in the 'SOS History' history
section should show up. This should be enough for basic network
connectivity tests.
Philip