On the Network tab for my probe, there is a section named, "Probe Address Discovery". It shows the addresses on my probe, placing a green check mark next to the one(s) it thinks are the public address(es) for the probe. For my probe, the IPv4 address shown in the IP Echo Service row has a green check mark. Unfortunately, that IPv4 address was replaced about a month ago by another IPv4 address, and it can no longer be considered to be an address for my probe. Additionally, the IPv6 address for the IP Echo Service is also incorrect, but that one doesn't have a green check mark next to it. Is it a problem that these addresses are incorrect? Is there a way to refresh them, or have them refreshed, with the correct IP addresses? thanks.