Hi, is there a simple way to check the reachability of IPv6 targets by probes behind NAT64? e.g. If I try to ping www.t-online.de with Adress Family IPv6 I get immediately the error " No IPv6 address found for target" instead of "measuremnet created". Same problem exists for DNS measurements. Regards, thomas
Am 21.02.20 um 14:38 schrieb Thomas Schäfer:
Hi,
is there a simple way to check the reachability of IPv6 targets by probes behind NAT64?
IPv4 targets of course.
On 2020/02/21 14:50 , Thomas Schäfer wrote:
Am 21.02.20 um 14:38 schrieb Thomas Schäfer:
Hi,
is there a simple way to check the reachability of IPv6 targets by probes behind NAT64?
IPv4 targets of course.
On NAT64, an IPv4 address is accessed over IPv6. You do need to disable the check if the domainname exists.
participants (2)
-
Philip Homburg -
Thomas Schäfer