Cannot change network configuration
Hello, I have recently changed the router that my Atlas probe is connected to. Since it is now in a separate subnet from my home LAN, with dedicated DHCP/RA configuration, there is no longer need for static address configuration, so I would like to revert its settings back to autoconfiguration for both IPv4 and IPv6. However, in the web interface,//"Change Probe's Network Configuration" menu is greyed out, so I cannot do anything even though the probe is up. What am I to do? Thank you, Tibor
On 10/03/2012 05:02 PM, Tibor Djurica Potpara wrote:
I have recently changed the router that my Atlas probe is connected to. Since it is now in a separate subnet from my home LAN, with dedicated DHCP/RA configuration, there is no longer need for static address configuration, so I would like to revert its settings back to autoconfiguration for both IPv4 and IPv6.
However, in the web interface,//"Change Probe's Network Configuration" menu is greyed out, so I cannot do anything even though the probe is up.
There was an issue with some code that we deployed recently that caused some problems with the static configuration of probes. As a temporary stop-gap measure, we disabled this feature on the site and have since worked to repair the issue in development. We will be deploying a new version of the site next week, at which point this feature will be stable and re-enabled. Unfortunately, you will have to wait until then. My apologies for any inconvenience this may have caused.
On 10/03/2012 05:15 PM, Daniel Quinn wrote:
There was an issue with some code that we deployed recently that caused some problems with the static configuration of probes. As a temporary stop-gap measure, we disabled this feature on the site and have since worked to repair the issue in development.
Is this also the reason that the probe that I received last week died on it's static IP configuration (Ticket 1060049)? -- Met vriendelijke groet / Best regards, Jan Hugo Prins Infra consultant E: jprins@betterbe.com T: +31-53-4800694 M: +31-6-26358951 S: jhaprins W: www.betterbe.com
On 10/3/12 22:54 , Jan Hugo Prins wrote:
On 10/03/2012 05:15 PM, Daniel Quinn wrote:
There was an issue with some code that we deployed recently that caused some problems with the static configuration of probes. As a temporary stop-gap measure, we disabled this feature on the site and have since worked to repair the issue in development. Is this also the reason that the probe that I received last week died on it's static IP configuration (Ticket 1060049)?
Unfortunately, yes.
participants (4)
-
Daniel Quinn -
Jan Hugo Prins -
Philip Homburg -
Tibor Djurica Potpara