My probe (10047) is dead
Hi Ripe, it looks like my probe is dead. Connection on site is working but probe doesn't seems to be connected. There is flashing orange led on USB dongle. What should I do now? How can I debug it? Best regards, Ondrej Flidr
On 18.06.2021 16.17, Ondrej.Flidr wrote:
Hi Ripe, it looks like my probe is dead. Connection on site is working but probe doesn't seems to be connected. There is flashing orange led on USB dongle. What should I do now? How can I debug it?
With mr3020 probes, the first step is usually to find a blank, non-defective 4GB or larger usb stick and swap it out. Particularly because the probe has the 'no flash drive' tag. (the probe will/should initialize the stick the way it likes it) Mine is on its third stick, and younger (15105) than yours. /Kasper Pedersen
On Fri, 18 Jun 2021, Kasper Pedersen wrote:
On 18.06.2021 16.17, Ondrej.Flidr wrote:
it looks like my probe is dead. Connection on site is working but probe doesn't seems to be connected. There is flashing orange led on USB dongle. What should I do now? How can I debug it? With mr3020 probes, the first step is usually to find a blank, non-defective 4GB or larger usb stick and swap it out. Particularly because the probe has the 'no flash drive' tag. (the probe will/should initialize the stick the way it likes it) Mine is on its third stick, and younger (15105) than yours.
When it happened to one of my probes earlier this year, I moved the USB-stick to a Linux computer and ran a "badblocks -svw" on the stick. It didn't find any bad blocks and the probe is still using the same USB-stick as it has been since 2014-01-06. Might be a solution if you don't want to buy a new USB-stick and just want to get the probe up and running again. -- Povl Ole
Hi Ondrej, It is a known issue and can be caused by the filesystem corruption on the USB drive or permanent failure of the USB drive. Please read about the remedy here: https://labs.ripe.net/author/philip_homburg/troubleshooting-ripe-atlas-probe... On 6/18/21 4:17 PM, Ondrej.Flidr wrote:
Hi Ripe, it looks like my probe is dead. Connection on site is working but probe doesn't seems to be connected. There is flashing orange led on USB dongle. What should I do now? How can I debug it?
Best regards, Ondrej Flidr
wbr RIPE NCC R&D /vty
Le 18/06/2021 à 16:17, Ondrej.Flidr a écrit :
Hi Ripe, it looks like my probe is dead. Connection on site is working but probe doesn't seems to be connected. There is flashing orange led on USB dongle. What should I do now? How can I debug it?
Best regards, Ondrej Flidr I have had the same case on my probe for months.
participants (5)
-
Kasper Pedersen -
Ondrej.Flidr -
Povl Ole Haarlev Olsen -
Viktor Naumov -
yves croison