Dear Jared,
... I think you’re speaking of just using the anchors?
Actually not. We are owner of Atlas probe: 35603 When I setup a new measurement I am asked to enter a number of probes. So I assume only probes are used for my measurement. Isn't it ? // Hans -----Original Message----- From: Jared Mauch <jared@puck.nether.net> Sent: Wednesday, May 22, 2019 3:31 PM To: Mayer Hans <Hans.Mayer@iiasa.ac.at> Cc: ripe-atlas@ripe.net Subject: Re: [atlas] RFC1918 probes
On May 22, 2019, at 8:40 AM, Mayer Hans <Hans.Mayer@iiasa.ac.at> wrote:
Dear All,
Looking at the result of a traceroute measurement I see very often that first hop has a RFC1918 address. These days a found a result where the first 3 hops are showing something like 192.168.x.y Of course this could falsify the result especially for response time. Is there a way to select only Atlas probes which are located in non RFC1918 networks ? If not it would be nice to have such a possibility.
I think you’re speaking of just using the anchors? - Jared