Hello, I got my new Atlas a few days ago and connected it to my network (in a separated VLAN). In this VLAN I'm announcing routing advertisements with autonomous IPv6 addressing enabled. Appearently the probe heard this advertisement and have chosen to communicate over IPv6 - but with a link-local IPv6 address only...?! This leads to "Beyond scope"-Messages from my router which I captured with tcpdump: fe80::280:a3ff:fe91:4070.58730 > 2a01:4f8:161:3281::43:148.443: Flags [S], seq 2585125851, win 5360, options [mss 1340,sackOK,TS val 4294950236 ecr 0,nop,wscale 1] fe80::225:90ff:fe92:2478 > fe80::280:a3ff:fe91:4070: ICMP6, destination unreachable, beyond scope 2a01:4f8:161:3281::43:148, source address fe80::280:a3ff:fe91:4070 My routing advertisements are currently looking like that: fe80::225:90ff:fe92:2478 > ff02::1: [icmp6 sum ok] ICMP6, router advertisement, length 64 hop limit 64, Flags [none], pref medium, router lifetime 1800s, reachable time 0s, retrans time 0s prefix info option (3), length 32 (4): 2a02:a00:e000:b:e6::/96, Flags [onlink, auto, router], valid time 86400s, pref. time 14400s mtu option (5), length 8 (1): 1400 source link-address option (1), length 8 (1): 00:25:90:92:24:78 Is there anything I can do to make the probe communicate over IPv6? Manual IP configuration is not possible since the menu item is greyed out (althrough my probe runs on FW 4470). I disabled RA at the moment so the Atlas cube can talk to the RIPEs Atlas servers. Thank you in advance! -- Greetings from Wuppertal, Germany Max Grobecker