Hello All, this might have been already asked/answered but I can't manage to find it. I've successfully compiled (RPSLng) IRRToolSet 4.8.2 under RedHat ES3.0 but soon realized that junos config option is not supported. Original SRCS && OBJS lines in the Makefile have been changed and all vendor specific modules, except for cisco, were excluded, i.e.: # $Id: Makefile.in,v 4.8.6.2 2004/07/16 16:41:50 katie Exp $ GOAL = RtConfig #OBJS = RtConfig.o command.y.o command.l.o f_bcc.o f_cisco.o f_gated.o f_rsd.o f_junos.o #SRCS = RtConfig.cc command.y.cc command.l.cc f_bcc.cc f_cisco.cc f_gated.cc f_rsd.cc f_junos.cc #HFILES = RtConfig.hh command.y.hh command.l.hh f_bcc.hh f_cisco.hh f_gated.hh f_rsd.hh f_junos.hh OBJS = RtConfig.o command.y.o command.l.o f_cisco.o SRCS = RtConfig.cc command.y.cc command.l.cc f_cisco.cc HFILES = RtConfig.hh command.y.hh command.l.hh f_cisco.hh Attempts to compile the code with any other vendor module added fail. So, my guess is that they have been commented for a reason. The same applies to "regular" 4.8.2 toolset, not only to RPSLng. At RIPE ToolSet test site, RtConfig (with RPSLng) (http://www.ripe.net/cgi-bin/RtConfig-rpslng.cgi) behaves the same way. Regular RtConfig instead, does accept junos config option, which most probably means that binary was produced from different (release of) source code. I would like to deploy RPSLng but I need "junos" support? How I can do that?? Thanks. Regards, Damir -- Damir Pobric Sr. Network Engineer CANARIE Desk: +1 613 944 5608 CA*net 4 NOC: +1 613 944 5612 damir.pobric@canarie.ca www.canarie.ca Ten Years of Innovation CANARIE 1993 - 2003