Folks, If you follow the 6man working group of the IETF you may have seen a bunch of emails on this topic, on a thread resulting from an IETF Internet-Draft we published with Jan Žorž about "Reaction of Stateless Address Autoconfiguration (SLAAC) to Renumbering Events" (Available at: https://github.com/fgont/draft-slaac-renum/raw/master/draft-gont-6man-slaac-... ) Short version of story: There are a number of scenarios where SLAAC hosts may end up using stale configuration information. For example, a typical IPv6 deployment scenario is that in which a CPE router requests an IPv6 prefix to an ISP via DHCPv6-PD, and advertises a sub-prefix of of the leased prefix on the LAN-side, via SLAAC. In such scenarios, if the CPE router crashes and reboots, it may loose all information about the previously-leased prefix. Upon reboot, the CPE router may be leased a new prefix that will result in a new sub-prefix being advertised on the LAN-side of the CPE router. As a result, hosts will normally configure addresses for the newly-advertised prefix, but will normally also keep (and use) the previously-configured (and now stale!) IPv6 addresses, leading to interoperability problems. The RIPE-690 BCOP document had originally tried to address this problem by recommending operators to lease stable IPv6 prefixes to CPE routers. However, for a variety of reasons ISP may not be able (or may not want) to lease stable prefixes, and may instead lease dynamic prefixes. Most of the voices on the 6man wg mailing-list fell into one of the following camps: * "ISPs should be leasing stable prefixes -- if they don't, they are asking for trouble!" * "CPE routers should record leased prefixes on stable storage, such that they can 'deprecate' such prefixes upon restart -- if they don't, they are asking for trouble!" * "No matter whose fault is this (if there is any single party to blame in the first place), we should improve the robustness of IPv6 deployments" Our Internet-Draft tries to improve the current state of affairs via the following improvements: * Allow hosts to gracefully recover from stale network configuration information -- i.e., detect and discard stale network configuration information * Have SLAAC routers employ more appropriate timers, such that information is phased-out in a timelier manner -- unless it is actively refreshed by Router Advertisement messages * Specify the interaction between DHCPv6-PD and SLAAC -- which was rather under-specified * Require CPE routers to store leased prefixes on stable storage, and deprecate stale prefixes (if necessary) upon restart We are looking forward to more input on the document (or any comments on the issue being discussed), particularly from operators. So feel free to send your comments on/off list as you prefer Thanks! Cheers, -- Fernando Gont SI6 Networks e-mail: fgont@si6networks.com PGP Fingerprint: 6666 31C6 D484 63B2 8FB1 E3C4 AE25 0D55 1D4E 7492